 |
MICROMOT 50 and 50/E precision milling/drilling machines. The ball bearing spindle and efficient cooling system provides for extended use.
Tens of thousands of these units in use speak for themselves. They are a joy to use. This is due to a number of factors, such as:
The diameter of only 1.4" (35mm) makes it easy to handle. Ther weight of 8.1 oz, quiet and effortless drive via the special motor, ground spindle and collar bearing all contribute to the ergonomic design. The high quality steel collets ensure accurate clamping of the cutters.
Mill/Drill unit 50/E
The electronic speed control enables the selection of speeds from 5,000 to 20,000 rpm. Phase angle control and feedback effect circuitry yield high torques, even at low speeds. Three MICROMOT collets for shanks covering .04", .09" and .12" (1.0, 2.4 and 3.0mm) are supplied. Power usage is 40W max. Length 8.6" and weight approx. 0.5lb.
Mill/Drill unit 50
Same as 40/E except no speed control is fitted. No load speed is 20,000 rpm.