Preac's Rotary table was designed to be used on its X - Y Table with The Preac Precision Drill Press. The combination of Rotary Table and X - Y Table may also be used on any other drill press with a good spindle. The Rotary Table alone can be used on any small milling machine where rotary milling or hole location is to be performed on a small scale. A .187" diameter hole is provided in the center of the table top to locate parts on the unit or with the drill press spindle. A 90 degree angle plate is also available to use the Rotary Table as a dividing head, to mill hex or square parts or drilling holes around the diameter of a part. The angle plate is made to fasten to the X - Y Table. The 1 1/2" or 2" vise can also be fitted to the Rotary Table or angle plate. Miniature straps or clamps are available to hold parts being machined to the Rotary Table, angle plate or directly to the X - Y Table top.
PRICES AND ACCESSORIES:
- Rotary Table....................$195.00..............All hardware included)
- Angle Plate........................$45.00
- Set of Clamps (2) 5/8".....$15.00
- Set of Clamps (2) 1"..........$17.00
Shipping..........$8.75 U.S. if ordered seperately. No shipping charge if ordered with X - Y Table.
The link below is a full 3 dimensional line drawing of the Rotary Table components. It is large and scanned for highest resolution possible, so may take a couple of minutes to load.
Line Drawing
Return to Preac Index
© Copyright 1997 Nature Coast Inc. arf@naturecoast.com